Quality and Compliance
This page states which documents exist for a VA-TEK instrument, and who issues them. It separates two things that are often conflated: the compliance position of the product, and the certification held by the facility that produced it.
Who issues what
| Document | Issued by | When supplied |
|---|---|---|
| Declaration of Conformity (CE), where the model carries one | Producing facility | With quotation or with shipment |
| Type-test / verification records, where they exist for the model | Producing facility | On request |
| Calibration documentation | Producing facility, or an accredited laboratory | With shipment |
| Unit test record against the datasheet specification | FESO, Shenzhen | With shipment |
| Final inspection record | FESO, Shenzhen | On request |
| RoHS / REACH declarations, where held | Producing facility | On request |
A certificate held by a producing facility is not the same document as a certificate held by the brand. If your tender requires ISO 9001, tell us at enquiry stage and we will confirm in writing whether a certificate exists for the specific model and producing facility — rather than imply that one document covers the whole range.
Design standards referenced
VA-TEK instruments are specified against the following standards. A standard being listed here is not, by itself, evidence of compliance: the evidence is the document set in the table above.
| Standard | Scope | Applicable products |
|---|---|---|
| IEC 61010-1 | Safety requirements for electrical test and measurement equipment | VA-TEK test instruments |
| IEC 61326-1 | EMC requirements for electrical measurement equipment | All products |
| IEC 60060 / IEC 60270 | High-voltage test techniques | VA-TEK high-voltage test equipment |
| RoHS 3 (EU 2015/863) | Restriction of hazardous substances | All products |
| REACH | Registration, evaluation, authorisation of chemicals | All products |
Calibration and verification
Calibration is an adjustment-then-verification process, not a printout of nominal values: where a channel is out of tolerance at the adjustment stage it is corrected and re-verified, and the final figures are what appear on the accompanying documentation.
The calibration document for a unit identifies it by serial number and model, lists the parameters covered, gives the reference standards and their traceability, states the measurement uncertainty, and carries the date and the recommended recalibration interval. That structure is what allows an asset owner to accept an instrument into a maintenance programme without re-verifying it on arrival.
Recalibration and repair
- Annual recalibration is the normal interval for instruments used in acceptance testing; a longer interval is acceptable where the instrument is used for maintenance testing only and a drift history supports it.
- Recalibration is arranged through the producing facility, or by an accredited third-party laboratory in your country where your quality system permits it.
- Repair returns follow a defined route: fault description, diagnostic report, quotation before work, then repair, recalibration and return with an as-found / as-left record.
- Firmware updates are supplied for the life of the instrument where the hardware supports them.
Working with your quality system
If your organisation requires a supplier qualification pack, an audit questionnaire, or specific wording in a Declaration of Conformity for a tender, tell us at enquiry stage and we will return the documents in your format. Where a requirement cannot be met by the instrument or the documentation available for it, we will state that in writing rather than let it be discovered at acceptance.
