Training & Education

VA-TEK supplies training-grade electrical test equipment to technical universities, vocational training centres, and the in-house training departments of utilities and testing service companies. The instruments are built on the same hardware platforms we ship to field commissioning crews, configured for classroom and laboratory use.

What we provide

  • Relay protection test sets for teaching secondary injection, protection scheme testing, and fault simulation.
  • CT/PT analyzers for ratio, polarity, excitation, and burden measurement exercises.
  • Transformer test instruments for turns ratio, winding resistance, and insulation power-factor laboratory work.
  • High-voltage cable test sets for introducing VLF withstand testing and cable diagnostics.

Built for teaching

Every unit ships with an operating manual, a documented test-connection scheme, and access to our application engineers for course preparation. Instruments use standard IEC and IEEE test methods, so laboratory exercises line up with the practices students will meet in service.

Discuss your requirements

Tell us which courses you run and the measurements you need to demonstrate, and we will recommend a configuration and supply a quotation. Contact our team or request a quote.

Course modules and the instruments behind them

Module Measurements demonstrated Instrument
Protective relay fundamentals Pickup, dropout, definite-time and inverse-time characteristics VAE-430
Differential and distance schemes Multi-end current injection, phase shift, zone reach VAE-660
Instrument transformers Ratio, polarity, excitation curve, knee point, burden VACTP200P
Transformer electrical testing Turns ratio, winding resistance, SFRA signature TTR-400, TWO-1100S, FRA100
Insulation diagnostics Power factor, capacitance, insulation resistance TDC-3100
MV cable testing VLF withstand at 0.1 Hz, leakage current interpretation VLF 30–90 kV family

What a teaching configuration includes

  • Instrument with the full lead and accessory set, so several student groups can work from one unit per bench.
  • Operating manual plus a documented test-connection scheme that maps each exercise to the terminals used.
  • Software licence for the test PC, with pre-built exercises and expected results for marking.
  • Calibration certificate, which matters when the laboratory measurement results have to be accredited.
  • Access to our application engineers for course preparation and for questions during the term.

Laboratory and safety considerations

Secondary-injection exercises work at low voltage and current, which makes them suitable for undergraduate laboratories. High-voltage exercises involving VLF testing of cable samples are a different category: they need a demarcated test area, earthing and discharge procedures, and supervision by someone trained in high-voltage practice. We will advise on which modules can run in a general laboratory and which require a high-voltage bay.

Because the instruments use the same test methods as field practice — IEC and IEEE procedures rather than simplified teaching modes — students meet the same terminology, connection schemes and acceptance criteria they will later meet in service. Course material aligns with the procedures described in our relay protection testing guide and VLF cable testing guide.

Related technical reading

Request a quotation   Talk to an application engineer

💬