cable testing

VLF vs Tan Delta vs Partial Discharge: Which Test Finds Which Fault

On 1 October 2026, ESCO Technologies completed the acquisition of Megger Group for roughly US$2.35 billion — about 14 times projected EBITDA, with the seller taking a fifth of the buyer in shares. Megger becomes part of ESCO’s Utility Solutions Group alongside Doble. Read that as a signal about where the money in cable testing […]

Read More →

IEC 60502-2 vs IEEE 400.2: Which VLF Test Applies to Your Cable?

Most VLF arguments on site are not about the test set. They are about which document the test has to satisfy. IEC 60502-2 is a cable standard that includes an after-installation test; IEEE 400.2 is a field-testing guide for installed cable systems. They overlap at 0.1 Hz, they answer different questions, and a specification that […]

Read More →

Choosing a VLF Test Set by Voltage Class: 11 kV to 66 kV

“Which VLF test set do I need for a 33 kV cable?” is the question buyers actually ask, and it has a definite answer: the set has to reach the test voltage the standard sets for that cable class, and it has to carry the cable’s capacitance at the frequency the test runs at. This […]

Read More →

IEEE 400.2-2024: What Changed and What a VLF Withstand Test Now Requires

IEEE 400.2 is the guide for field testing shielded power cable with very low frequency AC below 1 Hz. The active edition is IEEE 400.2-2024, which replaced IEEE 400.2-2013 and changed several of the criteria a compliant test is judged against — most importantly the basis of the test-voltage table, the minimum duration for higher-voltage […]

Read More →

VLF Test Set Verification and Field Calibration

A VLF test set is not only a source of high voltage; it is a measuring instrument. The voltage it reports is the voltage the cable is actually tested at, and the test is valid only if that number, the frequency below it and the shape of the waveform are what the set claims. A […]

Read More →

VLF Testing After Cable Repair and Fault Location

A cable fault is not over when the repair is finished. It is over when the repaired cable has been tested, the test has passed, and the circuit is restored with a record that will stand up. VLF is the tool that closes that loop, and the way it is used after a repair differs […]

Read More →