cable testing

VLF Testing of Cable Joints and Terminations

Ask a cable engineer where failures happen and the answer is rarely “the cable”. It is the joint. The terminations. The accessories, where the insulation is cut back, where a barrier was hand-assembled or machine-applied, where the environment finds a path in. A cable run between two well-made terminations is usually the most reliable part […]

Read More →

VLF Testing by Cable Type: XLPE, EPR and PILC Compared

VLF withstand testing is often described as if the procedure were the same for every cable. It is not. The voltage band, the value of a partial discharge reading, and the risks of the test itself all depend on what the insulation is made of. A procedure written for XLPE and applied unchanged to an […]

Read More →

VLF Partial Discharge Testing: Reading PD on MV Cables

A withstand test answers one question: did the cable survive. It cannot tell you whether the insulation is degrading, or how quickly. For that you add a diagnostic, and the most direct one is partial discharge — the small, localised breakdowns that precede most cable failures. Partial discharge can be measured at VLF, and doing […]

Read More →

VLF Test Voltage Selection: U0, 2U0 or 3U0 for MV Cables

Every VLF test starts with one number: the test voltage. There is no instrument that tells you the right value — you choose it from the cable’s rating, its age and the reason it is being tested. Choose it too high and you risk the insulation you set out to prove; choose it too low […]

Read More →